Ruijie Networks RG-N18010, Руководство по установке и справочное руководство по оборудованию

Страница: 102 / 144

Installing Power Supplies
The RG-N18000 series switches provide AC power supplies, including RG-PA1600, RG-PA600I and RG-PA1600I-P, and
DC power supplies, including
RG-PD1600I and RG-PD600I . Before performing the following procedures, wear an
anti-static wrist strap close to your kin and keep it grounded well.
The RG-N18014 power system provides eight power supply slots. It is recommended that you configure
N+M power supply redundancy.
The RG-N18010 power system provides eight power supply slots, which support N+M redundancy. The
power system also provides two PoE ports, which support 1+1 redundancy.
It is recommended that you
configure power supply redundancy.
When RG-N18014/RG-N18010 is powered up by more than one source, the power must be in the same
model.
If you want to carry or lift the power module, please hold the bottom of the module with your hand instead of
carrying the module by the handle. Otherwise, the module may be damaged.
Before inserting or removing the power module, please verify whether the switch is well mounted. The switch
is high, avoid switch tumble when you are inserting or removing the power module.
If you want to hot swap a power supply, please make sure that the interval between two operation is greater
than 30 seconds.
Please do not touch the connecting finger part of the power supply which is removed after power off in case
that capacitor discharge is not full.
 Install the AC power system
1) Loosen the captive screws on the filler panel covering the power slot at the rear of the chassis.
2) Insert the power module into the slot along the rail until the rear connector of the power module stays in good contact
with the rear panel.
3) Tighten the captive screws on the power module to fix it.
Figure 3-23 Installing Power Supplies