Ruijie Networks RG-N18010, Руководство по установке и справочное руководство по оборудованию

Страница: 109 / 144

Installing Swappable Interface Modules (Optional)
Make sure the optical modules connected to both ends of a fiber are the same type while replacing
swappable optical modules.
Preparation
1) Wear an anti-static wrist strap to your wrist and tighten the lock. Make sure it is properly grounded.
2) Take out the SFP+/SFP/QSFP+ module you want to install from packing bag. Do not touch the connecting finger on
the module.
Figure 0-32 Wearing an Anti-Static Wrist Strap
Installing SFP+/SFP Modules
To avoid damaging components due to operation errors, read this section carefully before installing
SFP+/SFP modules.
To install the SFP/SFP+ module, do as follows:
1) Turn up the handle of the module into the top bail-clasp latch. Hold both sides of the module and push the module
into place (You can feel that the module is placed in position with a click sound).
Figure 3-33 Installing the SFP/SFP+ Module
2) Use the fiber optical patch cord to connect the SFP/SFP+ module to the fiber optical network. Select the patch cord
with the connector corresponding to the port.
3) After the patch cord is connected, the Link/ACT Status LED is on. Otherwise, please check connection of the patch
cord.
Precaution
 If the SFP/SFP+ module cannot be inserted to the end, do not push it forcefully. Please try the other end of the
module.
 Do not touch the connecting finger on the module.
 Do not squeeze, bend or fold the optical fiber, which may cause system performance degradation or data loss.
 Do not remove the protective rubber plug from SFP+/SFP module before connecting fibers.