Ruckus Wireless ZoneFlex 7731, Руководство по установке

Страница: 40 / 64

36
Physical Installation
Attaching the Mounting Brackets
2. Verify that the Cat-5e FTP cable (outdoor-rated) from the Wireless Bridge is long
enough to reach the PoE injector that is installed indoors.
NOTE: Careful selection of Ethernet cable type is important in outdoor installations.
Outdoor-rated, FTP (foil twisted pair) or STP (shielded twisted pair) Category 5E cable
should be used. Additionally, UV protected cable may be necessary if the cables will be
installed under direct sunlight, smaller AWG rating cables should be used for long runs,
and shielded RJ-45 connectors should be used with cable that includes a drain wire.
3. Create a drip loop in any cable installed outdoors. This will prevent water from running
along the cable and entering the Wireless Bridge or the building where the cable
terminates.
4. Verify that the RJ45 port on the Wireless Bridge is connected to the AP/BRIDGE port
on the PoE injector.
5. Connect the Ethernet cable from the NETWORK port on the PoE injector to your
network router or switch.
6. Apply power to the Wireless Bridge.
•
If you are using PoE, plug the power adapter in to an AC power source.
• If you are using DC power, connect the DC cable to a DC power source.
7. Verify that the PWR LED on the back of the Wireless Bridge is steady green.
8. Continue to “Attaching the Mounting Brackets” .
Attaching the Mounting Brackets
What You Will Need
To complete this procedure, you will need the following items:
■
Static bracket
■
Dynamic bracket
■
Wall anchors
■
Flat washers
■
Hex nuts
■
10mm ratchet wrench
If you are mounting the Wireless Bridge on a flat surface, you will also need an electric drill
with an 8mm drill bit.
If you are mounting the Wireless Bridge on a pipe or pole, you will also need the following:
■
A 30mm to 60 mm (1.18 in. to 2.36 in.) pipe or pole
■
Steel clamp
■
10mm flathead screwdriver