Ruckus Wireless ZoneFlex 7731, Руководство по установке

Страница: 15 / 64

11
Preparing for Installation
Point to Point Bridge Configuration
Point to Point Bridge Configuration
The following section provides instructions for configuring two ZoneFlex 7731 Wireless
Bridges for point to point bridging.
If you will be deploying more than one Non-Root Bridge, Ruckus Wireless recommends
first completing the Point to Point Bridge configuration, before proceeding to
“Point to
Multipoint Configuration” on page 20 .
CAUTION:
Do not attempt to access the Web interface of two ZoneFlex 7731 units at the
same time by connecting both to the same Layer 2 switch or to the same broadcast domain
on a live network. This will cause a network loop, which can disrupt your entire network.
Step 1: Supply Power to the Wireless Bridge
This procedure assumes that you will be using Power over Ethernet for the pre-installation
configuration, even if you plan to use DC power in the final deployment. For DC power
setup, see
“Use DC Power” on page 32 .
NOTE: You only need to connect one type of power source at this point, even if you are
planning to use both PoE and DC power in your final deployment.
Use Power Over Ethernet
1. Take out the PoE injector and the power adapter from the Wireless Bridge package.
2. Obtain two Ethernet cables.
3. Connect one end of one Ethernet cable to the AP/BRIDGE port on the PoE injector,
and then connect the other end to the RJ45 port on the ZoneFlex 7731.
4. Connect one end of the other Ethernet cable to the NETWORK port on the PoE
injector.
5. Connect the power jack to the DC 48V IN connector on the PoE injector, and then
plug the power adapter into a power source. The single LED on the PoE injector turns
red.
6. Check the power LED on the ZoneFlex 7731 to ensure power is being supplied to the
bridge.