Ruckus Wireless ZoneFlex 7731, Руководство по установке

Страница: 18 / 64

14
Preparing for Installation
Point to Point Bridge Configuration
1. On your Windows XP or Windows 2000 computer, open the Network Connections (or
Network and Dial-up Connections ) control panel according to how the Start menu is
set up:
• On Windows XP, click Start > Control Panel > Network Connections.
• On Windows 2000, click Start > Settings > Network Connections .
2. When the Network Connections window appears, right-click the icon for Local Area
Connection, and then click
Properties .
NOTE: Make sure that you configure the Local Area Connection properties, not the
Wireless Network Connection properties.
3. When the Local Area Connection Properties dialog box appears, select Internet
Protocol (TCP/IP) from the scrolling list, and then click Properties . The Internet
Protocol (TCP/IP) Properties dialog box appears.
4. Write down all of the currently active network settings. You will need this information
later when you restore your computer to its current network configuration.
5. Click Use the following IP address , and then configure the IP address settings with
the values listed in Table 4 . For a sample configuration, refer to Figure 7 .
You can leave the Default Gateway and DNS fields blank.
6. Click OK to save your changes and close the TCP/IP Properties dialog box.
7. Click OK again to close the Local Area Connection Properties dialog box.
Windows saves the IP address settings that you have configured. Your admin computer is
now ready for direct connection with the ZoneFlex 7731.
Table 4. Configure your computer’s IP address settings
IP address
192.168.2.22
(or any address in the
192.168.2.x
network—with the exception of
192.168.2.1
and
192.168.2.254
which will be used by the bridges)
Subnet mask
255.255.255.0