Ruckus Wireless ZoneFlex 7731, Руководство по установке

Страница: 53 / 64

49
Optimizing the Distance, Orientation and Channel
Aiming
Figure 44. Setting the distance between bridges
Aiming
■
Aiming in a Point to Point Deployment
■
Aiming in a Point to Multipoint Deployment
Aiming in a Point to Point Deployment
Once both units are installed in their permanent locations, press the Aiming Button on
the outside of either unit to begin aiming. Alternatively, you can start the aiming process
via the Web browser, by clicking
Start Aiming on the Status > Wireless page.
The following section describes the procedure for aiming a pair of ZoneFlex 7731 Wireless
Bridges in a point to point configuration. For information on aiming in a point to multipoint
deployment, see
“Aiming in a Point to Multipoint Deployment” on page 51 .
1. Press the blue button on the side of either bridge and hold it for 4 seconds.
• The bottom LED turns yellow, indicating that the unit is in Aiming Mode.
• If the unit is in Aiming mode but there is no association between the two bridge
units, all LEDs will cycle yellow until the two ZoneFlex 7731 units have associated.
2. Adjust the azimuth and elevation of the first unit to maximize the Aiming LED indica-
tors. RSSI (received signal strength indication) values are shown in
Table 5 .