RTS CS9500, Руководство пользователя

Страница: 10 / 95

Operation Guide RTS Systems Division
ke
.
In
general, you will also need to use the listen key,
SO
it should
(auto follow), or (auto
Note that the only responds to commands which are sent via a point to point key
assignment. If you wish to use the primarily on a you must add a point to point
assignment
as
the talk assignment on the talk key for any panels which are going to
either answer the line, or dial out on the line.
3.1.2 Dialing a
call:
Any key panel may dial calls on the TIF-951.
To dial a call on the
1.
Turn on the listen key for the line you wish to dial on. This
will
allow you to hear
dial tone, and your DTMF tones.
2. Enter dial mode by entering P ONE-PGM-T.
PHONE is
the 4 button
on
the
keypad. PGM is the red PGM key on the key pad, and
T is
the talk key which is
programmed to talk to the you
are
dialing
on.
Leave the talk key in the up
engaged position as you dial the number.
3.
Dial the number.
As
you enter each digit, it will appear in the alpha display above
the ke you
are
dialing
on.
On panels with LED
tally,
the
LED
will flash
on
each
digit. f the listen key engaged, you will hear each
DTMF
tone as it is generated.
4.
When you have completed momentarily disengage the talk key to exit dial
mode. The alpha numeric display will revert to
normal,
and you may use the key
and key pad in the normal manner.
Note: The key pad is used in the usual way. Digits generate the
DTMF
digits
9. PGM generates
#,
and generates and are displayed for these keys).
If the last number dial option is resent, it is necessary to press CLR
twice if you wish to generate a
as
a single LR is used to trigger the speed dial
and redial features.
3.1.3 Hanging
up:
The will detect that the caller at the far end has hung up under most circumstances.
It detects the hang up by either loop interrupt, battery reversal, or the presence
of
dial
tone. Some telephone systems do not provide any of the above, so it will be to
force a hang up. In addition, if the call was placed to an auto device, it be
necessary
to
force a hang up when the call
is
complete.
Enter PHONE-CLR-t, where PHONE is the
4
button
on
the
key pa4 0 is the 0
button, PGM is the red PGM button, and
t
is the talk key which is programmed to
talk to the which you wish to
hang
up.
This
will disconnect the line for
which you struck the talk key.
Note that if the talk
key
is in
the
on position, you must
turn
off the key, then
momentarily turn it on again to indicate which
line
you wish
to
disconnect. If the
line is in dialing mode, then you must first exit dialing mode by turning off the key,
then use PHONE-CLR-t
to
hang up.
Rev
B
Page 6 Telex Communications, Inc.