RSP P0101, Руководство по эксплуатации продукта

Страница: 31 / 38

M0106-1 ver 2.3 31
4.4 Replacement of wear parts
4.4.1 Replacement of air sealings
4.4.2 Replacement of signal pins (TC20-4E only)
Replace a signal pin when worn or damaged.
Action Note
1 Remove air sealings Remove the air sealings with a screw driver.
NOTE! There are totally 4 air sealings.
2 Clean sealing holes Wipe clean the sealing holes. Remove all
remaining parts of sealing and glue.
3 Replace air sealing Glue the new air sealing in the sealing groove.
Use a small amount of Loctite 480 (or similar).
Press the sealing 60-120 seconds until the glue
hardens.
Action Note
1 Power off Switch the power off and lock the circuit
breaker.
2 Remove signal pins Pull out the signal pins with a pair of pliers.
NOTE! There are totally 8 signal pins.
3 Replace signal pins Fit the new signal pins by pushing them into
the sleeves.
NOTE! The signal pins should be fully pressed
into the sleeve using a small screwdriver.
4 Power on Unlock the circuit breaker and switch the power
on.