Instalattion and operating manual: MGSM 5.0/MGSM 5.0-PS v.1.8S EN
8.
MODULE OPERATION SATUS SIGNALING
The MGSM 5.0/5.0-PS module is equipped with an optical
status signaling system. Four LED diodes mounted on the
module board display the operation status of: signaling,
communication with PC, software update.
LED
Color
COMM
GREEN color
SEND
YELLOW color
LOG
BLUE color
FAIL
RED color
INCOM
YELLOW color
●
COMM:
NORMAL STATE (without signaling and programming action)
– short flashes every ca.
1 second = satisfying between the module and telephone
●
SEND:
ALARM ACTION:
signaling via SMS messages and voice messages is performed according to
the following procedures:
SMS
-
1 flash = send SMS to NUMBER 1,
-
2 flashes = send SMS to NUMBER 2,
-
3 flashes = send SMS to NUMBER 3,
-
4 flashes = send SMS to NUMBER 4,
VOICE MESSAGES
-
1 flash = connection to NUMBER 1,
-
2 flashes = connection to NUMBER 2,
-
3 flashes = connection to NUMBER 3,
-
4 flashes = connection to NUMBER 4,
PROGRAMMING (communication with PC):
– flashes ca. every 1 second. = connection with service computer
Remarks:
●
if the signaling is not pre-programmed for a given PHONE NUMBER, the module
will go to the next set job (signaling)
●
LOG:
NORMAL STATE
-
series of 1 to 5 short flashes every ca. 2 seconds = GSM network signal level (1-min. 5 =
max.)
- no flashes = telephone not logged in GSM network
●
FAIL:
NORMAL STATE
series of 1 to 10 short flashes every ca. 2 seconds = state of FAILURE
1 - low network signal level, below 2 “dashes”
2 – telephone not logged in network
3 – unsuccessful attempt to send 3 consecutive SMS messages
4 - low power supply voltage U<11V on the power supply input
5 – overloaded O1 high current output (I>1A)
6 – no communication with the module telephone
45
