Instalattion and operating manual: MGSM 5.0/MGSM 5.0-PS v.1.8S EN
●
TYPE:
●
INFO
- data on input does not trigger the alarm function, but initiates SMS sending
and the call queuing process.
●
24h-
module enters the alarm state, sends SMS messages and makes calls,
independently of whether it is in the standby mode or not.
●
INSTANT -
the line initiates the alarm,
SMS messages and calling when the
module is in the armed mode.
●
ARM/DISARM-
switching ARM/DISARM line, violation switches standby mode on, end
of violation switches it off. Line can operate also in the pulse mode (“pulsed line”
option on) as follows: first violation arms the module, the second violation disarms it
and so on alternately. The ARM/DISARM line can switch the SMS and voice signaling
off when the option SIGNALLING OFF is marked (signaling will be terminated when the
module is disarmed, independently of the signaling function progress!).
•
DELAYED -
line triggers the alarm, SMS messaging and calling after time for entry
has elapsed, only when the module is disarmed. The time for entry can be set in the
OPTIONS bookmark.
INTERIOR DELAYED
- the line triggers the alarm, text messaging (SMS) and calling
after the time for entry has expired and the armed mode has not been switched off, if
the DELAYED entry has been violated in the first place. Otherwise, it operates as a
NORMAL entry.
The time for entry can be set in the OPTIONS tab.
•
COUNTING
– violation of this type of line will result in the incrementation of the
violation counter and when it reaches it’s value, it initiates the alarm procedures. The
line is active in the module standby mode (exactly like the NORMAL) and the violation
counter is reset after a certain time measured from the last violation.
e.g. for values as in the diagram, to initiate the alarm from the counter line, it should be
violated 2 times at intervals not longer than 60 seconds.
•
REACTION TIME
This parameter determines the time in ms (1s=1000ms), during which the input must be
violated to detect it’s change of state. For each input, the reaction time can be set
independently (500 ms by default)
•
FLASH
Determines whether the sent SMS message is to be displayed directly on the telephone
screen (flash), or whether it should be read from the “received mail” box. Selecting the
option configures the input SMS type for the “violation” and “entry restore”
Remarks:
●
it should be remembered that FLASH type SMS messages can be very easily
overlooked, because they are not recorded in the telephone (they disappear
from the telephone screen when there is an incoming call)
●
the FLASH option may not be available while sending SMS messages to a different
operator than the one whose card is in the module (this does not depend on the
settings but it is a result of limitations imposed by operators!).
●
BLOCK FOR
The time of blocking the input (response) after the first violation. This option is active for the
following TYPES of entry: INFO, NORMAL, DELAYED, INTERNAL DELAYED, 24H. The time of
blocking can be set separately for each entry (the default setting is 0s). Min/max time =
1/360min (this option is used for limiting the number of messages and when using the MGSM
5.0/5.0-PS as an alarm control panel; it enables actual control of the armed mode through
the SMS messages).
•
VSR
This column enables configuring the content of voice messages, in cooperation with the VSR-
2 Voice Synthesizer.
20
