61
Chapter 5 Using Pedals to Control the Effects
Chapter
5
Active Range
fig.05-180d
This sets the operational range within which the value of the
setting changes when an expression pedal or other controller
that changes the value consecutively is used as the source. If
the controller is moved outside the operational range, the
value does not change, it stops at “minimum” or
“maximum.”
(Example)
With Act. Range Lo: 40, Act. Range Hi: 80
fig.05-190
fig.05-200
* When using a foot switch or other on/off switching controller
as the source, leave these at “Lo: 0” and “Hi: 127.” With
certain settings, the value may not change.
Internal Pedal System
The GT-8 features a function called Internal Pedal system.
This function assigns specified parameters to a virtual EXP
pedal (the internal pedal), providing an effect that changes
volume and tone in real time just the way an expression
pedal functions.
The Internal Pedal system features the following two
functions, allowing you to set “Source” for each assign
number (1–8) of the Assign Variable.
❍
Internal Pedal
❍
Wave Pedal
* When the Internal Pedal is used as a Wave Pedal, set the
ASSIGN Source Mode to Normal.
Internal Pedal
With the trigger you have set, the assumed EXP pedal starts
working. If you have set “Internal Pedal” to “Source,” set the
following parameters.
maximum value
minimum value
0
40
80
127
Target
Max
Target
Min
Act.Range
Lo
Act.Range
Hi
Off
On
Off
Center
value
On
0
40
80
60
127
Act.Range
Lo
Act.Range
Hi
Parameter/
Range
Explanation
Trig (Trigger)
fig.05-210d
see below
This sets the trigger that activates the virtual
EXP pedal.
PatchChange
This is activated when a patch is selected.
EXP PEDAL-L
This is activated when the EXP pedal on the GT-8 is returned.
EXP PEDAL-M
This is activated when the EXP pedal on the GT-8 is depressed.
It does not start working until the pedal is depressed as deeply as up
to the middle.
EXP PEDAL-H
This is activated when the EXP pedal on the GT-8 is depressed.
It does not start working until the pedal is depressed deep down.
CTL PEDAL
This is activated when the CTL pedal on the GT-8 is depressed.
EXP SW
This is activated when the EXP pedal switch on the GT-8 is turned
on.
SUB EXP PEDAL
This is activated when the EXP pedal connected to the SUB EXP
PEDAL/SUB CTL 1, 2 jack is depressed.
SUB CTL 1
This is activated when the foot switch 1 connected to the SUB EXP
PEDAL/SUB CTL 1, 2 jack is depressed.
SUB CTL 2
This is activated when the foot switch 2 connected to the SUB EXP
PEDAL/SUB CTL 1, 2 jack is depressed.
GT-8_e.book 61 ページ ２００７年６月２９日 金曜日 午後３時５５分
