81
Chapter 8 Using the GT-8 with External MIDI Devices Connected
Chapter
8
Transmitting and Receiving
MIDI Data
On the GT-8, you can use Exclusive messages to provide
another GT-8 with identical settings, and save effect settings
on a MIDI sequencer or other device.
Transmitting data this way is called “Bulk Dump,” while
receiving such data is referred to as “Bulk Load.”
Transmitting Data to an External
MIDI Device (Bulk Dump)
The following types of data can be transmitted. You can
transmit data by specifying the range from the start to the
end of transmission.
Making the Connections
When Saving to a MIDI Sequencer
Connect as shown in the figure below, and put the sequencer
in the state where it is ready to receive Exclusive messages.
fig.08-140
* For instructions on operating the sequencer, refer to the
owner’s manual for the sequencer you are using.
* On the GT-8, Bank Select messages are output simultaneously with
Program Change messages. For more details, reefer to p. 85.
MIDI EXP OUT (MIDI EXP Pedal Out)
fig.08-090d
Off, 1–31, 33–95
This sets the controller number when EXP
pedal operation data is output as Control
Change messages.
When set to “Off, “Control Change messages are not output.
MIDI EXP SW OUT (MIDI EXP Pedal Switch Out)
fig.08-100d
Off, 1–31, 33–95
This sets the controller number when EXP
pedal switch operation data is output as
Control Change messages.
When set to “Off, “Control Change messages are not output.
MIDI CTL OUT (MIDI CTL Pedal Out)
fig.08-110d
Off, 1–31, 33–95
This sets the controller number when CTL
pedal operation data is output as Control
Change messages.
When set to “Off, “Control Change messages are not output.
MIDI SUB CTL1 OUT
fig.08-120d
Off, 1–31, 33–95
This sets the controller number when opera-
tion data from the foot switch 1 connected to
the SUB EXP PEDAL/SUB CTL 1, 2 jack is
output as Control Change messages.
When set to “Off, “Control Change messages are not output.
MIDI SUB CTL2 OUT
fig.08-130d
Off, 1–31, 33–95
This sets the controller number when opera-
tion data from the foot switch 2 connected to
the SUB EXP PEDAL/SUB CTL 1, 2 jack is
output as Control Change messages.
When set to “Off, “Control Change messages are not output.
Parameter/
Range
Explanation
Displayed
Data Transmitted
System
System Parameters, Harmonist scales,
Auto Riff phrases, and
Preamp/Speaker, Overdrive/Distortion,
and Wah Custom Edit parameter settings
Quick
Settings for User Quick Setting
#1-1–#35-4
Settings for Patch Number 1-1 through 35-4
Temp
Settings for the patch the is currently called
up
MIDI OUT
MIDI IN
GT-8_e.book 81 ページ ２００７年６月２９日 金曜日 午後３時５５分
