Roland EGX-20, Руководство пользователя

Страница: 35 / 52

 Make sure the Z-axis light on the switch panel is illuminated, then press and hold the Origin
Set button for a short while (0.3 second or more).
(Pressing the Origin Set button lights the Origin Set light. Make sure the light is illuminated, then release
the button. The Origin Set light goes dark.)
Setting the Origin Point for the Vertical and Horizontal Position
 Refer to "Basic Steps for Moving the
Spindle Unit" on page 19 and move
the spindle unit so that the cutter is
positioned above the lower left corner
of the material.
Lower the spindle unit to check
whether the cutter is at the lower left
corner.

If the Z-axis light on the switch panel is illuminated, press and hold the center of the move-
ment button for a short while (0.6 second or more).
Make sure the Z-axis light is dark, then press and hold the Origin Set button for a short
while (0.3 second or more).
(Pressing the Origin Set button lights the Origin Set light. Make sure the light is illuminated, then release
the button. The Origin Set light goes dark.)
You can set the height origin point by pressing the Origin Set button when the Z-axis light is illuminated.
You can set the origin point for the vertical and horizontal position by pressing the Origin Set button when the
Z-axis light is dark.
Material
Move the cutter to this location.
33 4 Creating a Relief (3D Cutting Mode)