Insert the cutter into the hole in the
cutter holder, then slowly lower the
cutter.
Lower it until the cutter touches the adhe-
sive sheet.
Use the included hexagonal wrench
to tighten the retaining screw for the
cutter holder and secure the cutter in
place.
Loading Material
You use the included adhesive sheet to secure material to engrave to the table on the EGX-20.
If the View light is dark, then press the View button.
The carriage moves to the right edge and the table moves to the front, the unit goes into View status, and
the Power and View lights light up.
NOTICE
Before you load material, attach the included adhesive sheet. Be sure the unit is in View status when loading
material.
P. 10, "Attaching the Adhesive Sheet"
31
4 Creating a Relief (3D Cutting Mode)
Содержание EGX-20
Страница 51: ......