R&S NRP-Z28/-Z98
Connecting the sensor
1170.8966.12
1.7
E-6
Operation via the R&S NRP-Z4 passive USB adapter
Fig. 1-3 is a schematic of the measurement setup. The order in which the cables are connected is not
critical.
Fig. 1-3
Power measurement on PC with the R&S NRP-Z4 passive USB adapter
Operation via the R&S NRP-Z3 active USB adapter
Fig. 1-4 shows the configuration with the R&S NRP-Z3 active USB adapter. The order in which the
cables are connected is not critical.
Fig. 1-4
Power measurement on PC with the R&S NRP-Z3 active USB adapter
The plug-in power supply for the R&S NRP-Z3 can be powered from a single-phase AC source with a
nominal voltage range of 100 V to 240 V and a nominal frequency between 50 Hz and 60 Hz. The plug-
in power supply autosets to the applied AC voltage. No manual voltage selection is required.
The plug-in power supply comes with four primary adapters for Europe, the UK, the USA and Australia.
No tools of any kind are required to change the primary adapter. The adapter is pulled out manually and
another adapter inserted until it locks (Fig. 1-5).
DUT
G
P
Ext. triggering
(optional)
(not included in delivery)
BNC cable
Plug-in power supply
(optional use)
G
R&S NRP-Z28/-Z98
G
DUT
P
R&S NRP-Z4
R&S NRP-Z28/-Z98
USB
TTL /
CMOS
R&S NRP-Z3
