Roger Technology B70/1DC, Инструкции и предупреждения для установщика

Страница: 71 / 296

EN
71
11
Travel acquisition
For the system to function correctly, the barrier travel must be acquired by the controller.
11.1
Before starting:
IMPORTANT:
Select the automation system model installed with the parameter $
.
KEY: HIGH SPEED Motors Reversible Motor
SELECTION MODEL MOTOR TYPE CONFIGURATION
D
BH30/600 / /
D
BH30/800 / /
D
BH30/500/HS
BH30/600/HS
see chapter 14 "Special Parameters for High Speed Motor"
D
BM30/400 /
D
BM30/300/HS see chapter 14 "Special Parameters for High Speed Motor"
D
BH30/804/R see chapter 15 "Special Parameters for Reversible Motor"
1. Select the position of the motor relative to the gate with the parameter . The default setting for this parameter
is with the motor installed on the right hand side of the gate (seen from interior side).
LEFT OPENING RIGHT OPENING
2. Adjust the (mechanical or magnetic) limit switches so that, once triggered, the gate stops slightly before it
reaches the mechanical stop.
CLOSING LIMIT SWITCH
OPENING LIMIT SWITCH
3. Check that the operator present function is not enabled (
$
).
OPEN CLOSE STOP
4. Move the gate into the closed position.
5. Press TEST (see TEST mode in chapter 10) and check the command signal and safety device states. If any
safety devices are not installed, jumper the relative contact or disable the device from the relative parameter
( , , , , and ).