Roger Technology B70/1DC, Инструкции и предупреждения для установщика

Страница: 73 / 296

EN
73
12
Index of parameters
PARAM.
FACTORY
DEFAULT
DESCRIPTION PAGE
$ see chap. 13
Selecting automation system model 75
$
Automatic closure after pause time (from gate completely open) 75
$
Automatic gate closing after mains power outage 75
$
Selecting step mode control function (PP) 75
$
4VIƽEWLMRK
75
$
Condominium function for partial open command (PED) 75
$
Enabling operator present function. 76
$
Gate open indicator / photocell test function and “battery saving” 76
Setting deceleration during opening (and closing for BH30/600-BH30/800-
BM30/400 )
76
Setting deceleration during closing ( High Speed and Reversible Series only) 76
Setting gate open limit switch constant speed approach distance 76
Setting gate closed limit switch constant speed approach distance 76
Partial opening adjustment (%) 76
COR output operating mode 76
Setting automatic closing time 76
Enabling of management for opening with automatic re-closure exclusion. 77
Setting reverse time after activation of sensing edge or obstacle detection
(crush prevention).
77
Setting motor torque 77
Setting obstacle impact force sensitivity 77
Setting start acceleration during opening (and closing for BH30/600-
BH30/800- BM30/400 )
77
Setting start acceleration during closing ( High Speed and Reversible Series only) 77
Enabling maximum torque boost at start of manoeuvre 77
Setting motor torque during position recovery 78
Setting opening speed (%) (and closing for BH30/600-BH30/800-
BM30/400 )
78
Setting closing speed (%) ( High Speed and Reversible Series only) 78
Setting end of manoeuvre constant approach speed 78
Setting number of automatic closure attempts after activation of sensing
edge or obstacle detection (crush protection)
78
Setting photocell mode during gate opening (FT1) 78
Setting photocell mode during gate closing (FT1) 78
Photocell (FT1) mode with gate closed 78
Setting photocell mode during gate opening (FT2) 79
Setting photocell mode during gate closing (FT2) 79
Photocell (FT2) mode with gate closed 79
Enable close command 6 s after activation of photocell (FT1-FT2) 79
Setting motor stop distance 79
Selecting installattion position of motor relative to gate (seen from interior side) 79
'SRƼKYVMRKWIRWMRKIHKI'37
79
'SRƼKYVMRKWIRWMRKIHKI'37
79