Roco and Fleischmann Z21-BOOSTER Series, Руководство пользователя, Страница: 44 / 80

44
44
Z21
®_
Booster
With the Default Werte (default values) button, you can restore the factory default settings of the
Z21
®
-Boosters in the entry fields in the dialogue window.
With Lesen (read), the settings can be read out of the Z21
®
-Boosters and displayed.
With Schreiben (write), the values in the entry fields are transferred to the Z21
®
-Boosters.
With FW Update , the firmware in the Z21
®
-Boosters can be updated. The target version or information
concerning the progress of the update respectively is shown in the Update Info field.
In the interest of further development, we reserve the right to make improvements and extensions with
regard to the settings.
Configuration using POM write commands
The Z21
®
-Boosters can also be configured using POM programming commands as long as it is config-
uration mode. Should the Z21
®
-Boosters be connected via the B-Bus or the CDE port, it is only able to
accept POM write commands. If the Z21
®
-Boosters is connected via the CAN-Bus, it is possible to read
the configurations via POM.
The POM programming (“Programming on Main“ = programming on the main track) normally serves to
enable the programming of the locomotive decoder to be carried out at the main track. The Z21
®
-Boosters
can respond to these POM programming commands by way of exception when it is in configuration mode
–
and only then – as long as these are directed at the “locomotive address” 9806 . Should you coinci-
dentally have a locomotive with this address, please remove it from the track beforehand if necessary.
Switch the booster to configuration mode by pressing the STOP button for at least 2 seconds until the
status LED starts to flash green or red. Now release the button.
You can now change the settings by entering the following CV variables in the pseudo ”locomotive ad-
dress“
9806 via POM using a WLAN-MULTIMAUS
®
, MULTIMAUS
®
or another input device of your choice:
CV-Nr. Meaning r / w (CAN) Value
7 Firmware Major Version read only
8 Manufacturer code;
CV 8=8
 Restore works settings
read / write 161
10 CV 10=0

Quit configuration mode and return to
normal mode
only / write 0
65 Firmware Minor Version read only
8010806920 neu.indd 44 25.10.2018 13:04:45