30
Lower Leg Installation
Position the fork at an angle with the lower leg bolt holes oriented upward.
Angle a syringe fitting in each lower leg bolt hole so the oil will only contact
the inside of the lower leg.
Inject 5 mL of suspension oil into each lower leg through the lower leg bolt
hole.
NOTICE
Do not exceed the recommended oil volume per leg as this can damage
the fork.
Slide the lower leg assembly along the upper tubes until it stops and the air
shaft and damper shaft are visible through the lower leg bolt holes.
200 hour service only:
Use a pick and needle nose pliers to remove the old
crush washers from each bottom bolt.
Hold the crush washer with needle nose pliers and unthread the crush
washer from the bolt by turning the bolt counter-clockwise with a 5 mm hex
wrench.
NOTICE
Dirty or damaged crush washers can cause oil to leak from the fork.
Install the black bottom bolt into the spring side shaft of the lower leg. Install
the red bottom bolt into the damper side shaft of the lower leg.
15wt
RockShox standard syringe
5mL
4
5
6
Pick
Needle- nose pliers
5 mm
7
5 mm
6.8 N·m (60 in-lb)
5 mm
6.8 N·m (60 in-lb)
