Roche CoaguChek Pro II, Руководство оператора

Страница: 113 / 206

113
CoaguChek
®
Pro II · Operator’s Manual
If the Parameter Selection option is enabled in the
meter settings, you are now prompted to select the
parameter to be tested.
The testing procedure for both parameters is similar.
For illustration purposes testing with PT test strips is
shown as an example.
11 Touch the button to select the parameter you want
to use.
12 The test strip icon prompts you to insert a test
strip. Remove a test strip from its container and
close the container again with the stopper.
Exposure to external influences (such as humidity)
may deteriorate the test strips and may lead to error
messages. Therefore, always close the test strip
container immediately after removing a test strip.
13 Hold the test strip so the lettering with the test
name is facing upward.
14 Slide the test strip into the test strip guide in the
direction indicated by the arrows. Slide the test
strip in as far as it will go.
A beep indicates that the meter has detected the
test strip (provided the beeper is enabled).
If you use a new test strip lot and have not
inserted the code chip yet, you must do so now.
Otherwise you cannot perform a test. The meter
displays the number of the code chip belonging to
the new test strip lot. Depending on the setting,
you may also be required to run a liquid quality
control test at this point.
4 Testing a Blood Sample
• 4