15
EN
Question
Answer
The appliance does not turn on.
Please check to see the safety locking arm is correctly locked in verti
-
cal position and into the 2 grooves.
The Juice Extractor suddenly stops running.
Wet pulp can build up under the juicer lid if the juicing action is too
vigorous. Slow the juicing action by pushing the food pusher down
slower. Clean the mesh juicer filter and also the juicer lid.
Excess pulp building up in the stainless steel
mesh juice filter.
Stop the juicing process and remove the cover, then scrape off the
pulp. Re-assemble and begin juicing again. Try alternating vegetable
and fruit varieties (hard and soft).
Pulp too wet, reducing the extracted juice.
Try a slower juicing action by pushing the food pusher down more
slowly. Remove mesh filter and thoroughly clean. Rinse under hot
water. If the fine mesh holes are blocked, soak the mesh filter in a
solution of hot water with 10% lemon juice to unblock the holes.
Juice Extractor makes loud noise when turned
on.
Mesh filter is not properly snapped into position.
Can I clean all removable parts in the dishwa
-
sher?
Yes, except the motor unit.
Why does the motor produce an unpleasant
smell during processing?
It is very common for a new appliance to give off an unpleasant smell
or emit some smoke the first few times it is used. This occurrence will
stop after you have used the appliance a number of times. The ap
-
pliance may also give off an unpleasant smell or emit some smoke if it
has been used too long. In that case you have to switch the appliance
off and let it cool down for 60 minutes.
The Juice Extractor is a simple and easy appliance to operate if you follow the above care and maintenance instructions,
giving you hassle free use. Should you encounter any difficulty, please refer to the troubleshooting table below. If this does not
solve the problem, please feel free to contact our customer support hotline number
or email us at the address listed in the back of the manual.
Troubleshooting
1.Pull the locking arm back over the grooves on either side
of the juicer lid, then pull down.
2.Detach the pulp container and then remove the juicer
bowl and lid (as one unit).
3.Remove the mesh filter from the juicer bowl.
4.Wash all parts and attachments, pulp container, juice
bowl, juice lid, mesh filter and food pusher.
Disassembling Instructions
•If you are juicing herbs, sprouts or leafy green vegetables,
it is advisable to bunch them together to form a bundle or
juice them in the middle of a combination of ingredients on
low speed to obtain the best juice extraction.
•Always wash fruit and vegetables before juicing.
•To get the best results, please use fresh fruit and vege
-
tables for juicing.
•Peel citrus fruits, pineapples, melons, etc. before you juice
them.
•Stone cherries, plums, apricots, peaches, etc. before you
juice them.
Firstly, switch off at the power outlet and unplug the Juice
Extractor. As above, please ensure that you have disas
-
sembled the appliance before cleaning.
1.Wipe the motor base with a damp cloth.
2.Always make sure that the stainless steel mesh filter is
thoroughly cleaned after each use. To assist with cleaning,
soak the mesh filter in hot soapy water for approximately
10 minutes immediately after juicing is completed. If pulp is
left to dry in the filter, it may clog the fine pores of the filter
mesh, thereby lessening the effect of the Juice Extractor.
3.If the holes are blocked, soak in a solution of hot water
with 10% lemon juice to help loosen the blockage.
4.Do NOT soak the mesh filter in bleach.
5.Do NOT use abrasive cleaners or scouring pads to clean
any of the parts.
Cleaning, Care and Maintenance
CAUTION: The centre of the stainless steel mesh filter
contains small sharp blades to process fruit and vege-
tables. Do NOT touch the blades when handling to prevent
cuts and injuries.
6.Reassemble Juice Extractor after it has dried thoroughly.
Then store it in a cool, dry place.
Содержание TROPICO
Страница 22: ...22 robusta fr...
