Robur GA ACF60-00, Инструкция по установке, эксплуатации и обслуживанию

Страница: 77 / 96

Section INITIAL STARTUP AND MAINTENANCE
Ed. 04/2012
73
SECTION 5 INITIAL STARTUP AND MAINTENANCE
This section describes the initial start-up and maintenance operations.
5.1 INITIAL STARTUP AND ADJUSTING
Initial start-up
The initial start-up of the ACF should by done by a Robur S.p.A. Authorized
Technical Service Centre. .
Before starting up the ACF, read paragraph 1.1 on page 3 and also paragraph 2.1
on page 29.
If the ACF is connected to a DDC, perform the start-up only as described in the
manual provided with the DDC.
Before start-up of the ACF, check that:
The gas valve is open.
The ACF has electrical power: the main power switch must in the “ON” position.
the pressure and flow of the water circuit have been correctly set by the installer.
If these conditions have been satisfied, the initial start-up of the ACF may begin.
If there is an error in the start-up of the ACF, a corresponding code will appear on
the circuit board display which can be seen through the window in the front panel.
See the “TABLE OF OPERATING CODES” on page 83 for a list of these codes.
If an IRREGULAR or DANGEROUS situation occurs during the initial start-up (see below)
due to a NON-COMPLIANT installation of the appliance, the Robur authorized Technical
Service Centre will NOT intervene to perform the initial start-up.
In this case, a plumber or an electrician will perform the interventions indicated by the
Robur S.p.A. Authorized Technical Service Centre, who will then reperform the initial start-
up.
A successful initial start-up does NOT CERTITY that the appliance is compliant
with the current regulations, but only indicates that the ACF and the DDC (if
installed) function properly.