RKC INSTRUMENT SBR-EW180, Руководство пользователя

Страница: 126 / 234

7-2
IMSBR10-E1
Select On to set relays I01, I02, and I03
to reflash alarm operation.
Select On to set relay I01 to diagnosis
output.
Select the range of relays that are to
operate using AND logic.
Select the relay’s energized or
de-energized operation.
Select the relay’s hold or non-hold
operation.
Select the relay’s hold or non-hold
operation.
Set the interval of the high limit on
rate-of-change alarm.
Set the interval of the low limit on
rate-of-change alarm.
Set the hysteresis of the measurement
channels.
Set the hysteresis of the computation
channels.
The new setting takes effect.
(models with /M1)
ESC/?
Basic=Alarm
Diagnosis=Off
Reflash=Off
AND=None
Act=Energize
Behavior=Nonhold
Indicator=Nonhold
Increase=01
Decrease=01
Hysteresis=0.5%
Math hysteresis=0.0%
Alarm
Setting complete
Applying the Changes and Returning to Operation Mode
Press the key or
SHIFT
+ key to select
End
and then press the key. Press the
key to select
Store
and then press the key. The changes are applied, and the screen returns to
Operation mode. If you select
Abort
and press the key, the changes are discarded, and the screen
returns to Operation mode. Press the
ESC
key to return to the
Basic=
screen.
Explanation
Diagnosis
When set to On, alarm output relay I01 becomes a dedicated diagnosis output relay, and the operation is fixed to
OR, de-energized, and non-hold. Diagnosis output is a function which outputs a relay signal when an error is
detected in the recording section, burnout detection function, or the A/D converter.
7.1 Changing the Auxiliary Alarm Function