Rittal BC 1007 HS, Руководство пользователя

Страница: 41 / 92

41
3.15.2 Replacement

Re-install using the reverse order above

On the front of the Servo module removed, there is
an LED display card that needs to be transferred to the
new module. Remove the two retaining screws from
both units, unplug the card and plug it into the new
module. Tighten the screws.

Be sure that all connections are tight and that the
wires are installed in their original locations.

Reinstall all covers previously removed. The DC Bus
must be safely covered before power can be applied.

Once all connections have been terminated and checked, remove the lock-out and power
can be applied to the machine. Note: When first starting up, leave the electrical cabinet
door open and observe the startup sequence on the servo drives. After cycling through a
sequence of numbers (3, 4, 5, 7…)

The Power Control Module will have LED 1, 2 & 3 on or flashing green

LED BTB will be on (Telling us that we installed the termination plug on the top of the
drive correctly) and Uz ok LED will be off. The Uz light will turn on when the Servo Power
is turned on from the operator’s console.

From the windows screen, start TeamViewer and notify Rittal Automation Systems –
Technical Support. The machine is ready for checks and verification.