Rittal BC 1007 HS, Руководство пользователя

Страница: 38 / 92

38
Spindle Servo Drive Module
3.15.1 Removal
Note: This procedure will be used on Perforex BC 1007/1008 & 2014 (with slight changes noted)

Power down the Perforex machine and properly lock-out the disconnect for safety

Open electrical cabinet

Safety Check! Check for any incoming voltage on the Line Input terminals (Lower right of
the electrical cabinet)

The Spindle Servo Control Module for
the C-Axis Spindle is located on the far left of
the drive string (for all BC 2014 machines, it is
one module from the left). It is considerably
larger in height than the other modules.

Remove front cover of the C-Axis and
Z-Axis (BC 2014 remove X2 also) servo
modules, by pushing down on the cover
indentation, below the yellow caution sticker,
and pull cover away from the Servo
Controller. Lift straight up to disconnect the
upper hinge.

Disconnect cables from X15 & X16
(Encoder cable and I/O cable)

On the top of the controller,
disconnect X20 (Blue/White 24vdc wires) and
the ribbon cable that connects to the servo
module to the right (Z-Axis). On the BC 2014,
the X2 ribbon cable will also have to be
disconnected.