Rigol MSO5000 Series, Руководство пользователя

Страница: 134 / 358

RIGOL
Chapter 5 To Trigger the Oscilloscope
5-52 MSO5000 User's Guide
Trigger Output Connector
The trigger output connector ( [TRIG OUT] ) on the rear panel of MSO5000 series
can output trigger signals (hardware trigger) determined by the current setting.
Figure 5-23 Trigger Output Connector
Press
Utility

System

AUX Out to select "TrigOut”. A signal which reflects the
current capture rate of the oscilloscope can be output from the [TRIG OUT]
connector each time a trigger is generated by the oscilloscope. If this signal is
connected to a waveform display device to measure the frequency, the measurement
result is the same as the current capture rate.
Note: If you press Utility

System

AUX Out to select "PassFail", then in the
pass/fail test, when a pass/fail event is detected, the oscilloscope outputs a pulse
from the rear-panel [TRIG OUT] connector.
Tip
If you enable both Trigger zone A and Trigger zone B, then perform the "A&&B"
operation, and it will become the final trigger condition.
Trigger Output Connector
www.
GlobalTestSupply
.com
Find Quality Products Online at: sales@GlobalTestSupply.com