Ricoh LDD250, Руководство по обслуживанию

Страница: 306 / 459

SERVICE PROGRAM MODE
C262/C265 5-46 SM
11: 6-10-19, -20 (Low Temperature Mode – Normal/Thick Paper)
If temperature is 19 ºC or lower (measured by the drum thermistor), the separation
pressure is increased by 1 automatically for all settings. The maximum pressure is
6.
12: 6-11 (Friction pad)
The machine switches the friction pads depending on the paper type selected by
the user (standard, special, thick, user 1, user 2).
13: 6-12 (Paper clamping)
The machine clamps the paper or does not clamp it, depending on the paper type
selected by the user (standard, thick, thin, special, user 1, user 2).
The settings for user 1 and user 2 depend on the type of paper that the user has
set these up for.
14: 6-13 (Paper delivery table wing angle)
The machine lifts or lowers the wings depending on the paper type selected by the
user (standard, thick, thin, special, user 1, user 2).
The settings for user 1 and user 2 depend on the type of paper that the user has
set these up for.
15: 6-14~6-15 (1
st
Paper Feed Delay – Normal/Thick)
The timing for starting the paper feed motor can be adjusted. There is a separate
adjustment for each print speed.
It is controlled based on the start timing, after the first actuator on the rear of the
pressure cylinder turns on the feed start sensor.
CAUTION: Do not use this adjustment, unless you are instructed by your service
manager.
16: 6-16~6-17 (1st Paper Feed Pulse - Normal/Thick)
To improve the separation of paper, the paper feed roller is made to turn more
slowly. There is a separate adjustment for each print speed.
CAUTION: Do not use this adjustment, unless you are instructed by your service
manager.