Menu item
Description
PS SmartSwitch
On
Off
Sets the printer to automatically switch to PS emulation when a print job received
through a serial port requires it, regardless of the default printer language
Notes:
•
On is the factory default setting.
•
When the Off setting is used, the printer does not examine incoming data.
•
When the Off setting is used, the printer uses PCL emulation if PCL SmartSwitch
is set to On. It uses the default printer language specified in the Setup menu if
PCL SmartSwitch is set to Off.
NPA Mode
On
Off
Auto
Sets the printer to perform the special processing required for bidirectional
communication following the conventions defined by the NPA protocol
Notes:
•
Auto is the factory default setting.
•
When the On setting is used, the printer performs NPA processing. If the data is
not in NPA format, it is rejected as bad data.
•
When the Off setting is used, the printer does not perform NPA processing.
•
When the Auto setting is used, the printer examines data, determines the format,
and then processes it appropriately.
•
Changing this setting from the printer control panel and then exiting the menus
causes the printer to restart. The menu selection is updated.
Serial Buffer
Disabled
Auto
3K to <maximum size allowed>
Sets the size of the serial input buffer
Notes:
•
Auto is the factory default setting.
•
The Disabled setting turns off job buffering. Any jobs already buffered on the
disk are printed before normal processing is resumed.
•
The serial buffer size setting can be changed in 1-K increments.
•
The maximum size allowed depends on the amount of memory in the printer,
the size of the other link buffers, and whether Resource Save is set to On or Off.
•
To increase the maximum size range for the Serial Buffer, disable or reduce the
size of the parallel, USB, and network buffers.
•
Changing this setting from the printer control panel and then exiting the menus
causes the printer to restart. The menu selection is updated.
Job Buffering
Off
On
Auto
Temporarily stores jobs on the printer hard disk before printing
Notes:
•
Off is the factory default setting.
•
The Off setting does not buffer print jobs to the hard disk.
•
The On setting buffers jobs on the printer hard disk.
•
The Auto setting buffers print jobs only if the printer is busy processing data from
another input port.
•
Changing this setting from the printer control panel and then exiting the menus
causes the printer to restart. The menu selection is updated.
Understanding printer menus
174
Содержание hn1
Страница 125: ...3 Connect the answering machine or telephone to the adapter Answering machine Telephone Faxing 125...
Страница 240: ...3 Remove the jam 4 Close the rear door 5 Close the front door 6 Touch Continue Clearing jams 240...
Страница 246: ...4 Remove the separator roll 5 Remove the jammed paper 6 Reinstall the separator roll Clearing jams 246...
