PRINTER ENGINE SERVICE MODE
17 January, 2003
5-60
SP6-XXX (Peripherals)
6
Mode No.
(Class 1, 2, and 3)
Function / [ Setting ]
[DF Registration Adj.]
DF Registration Adjustment
1 Side-to-Side
2 Leading
Edge
Adjusts the side-to-side and leading registration of
originals with the ARDF.
[ -30 to 30 / 0 / 0.1 mm/step ]
3
Buckle: Duplex Front
4
Buckle: Duplex Rear
Adjusts the amount of paper buckle to correct
original skew for the front and rear sides.
[ -4.2 to 4.2 / 0 / 0.1 mm/step ]
006
5
Rear Edge Erase
*
NV
CF
Adjusts the erase margin at the original trailing
edge.
[ -20 to 10 / 0 / 0.5 mm/step ]
[ADF Input Check]
1 Group
1
007
2 Group
2
CF Displays the signals received from the sensors
and switches of the ARDF. (See 5.4.2)
[ADF Output Check]
1 Fee-in
Motor
Fwd.
2
Feed-in Motor Rev.
3
Drive Motor Fwd.
4
Reverse Motor Fwd.
5
Reverse Motor Rev.
6 Feed
Clutch
7 Inverter
Solenoid
8
Pick-up Motor Fwd.
008
9
Pick-up Motor Rev.
CF Activates the electrical components for functional
check.
It is not possible to activate more than one
component at the same time.
[DF Free Run]
1 Duplex
Mode
009
2 Stamp
Mode
CF Performs a DF free run in duplex mode or stamp
mode.
[Stamp Position Adj.]
Fax Stamp Position Adjustment
010
1
Stamp Position Adj.
*
NV
CF
Adjusts the horizontal position of the stamp on the
scanned originals.
[ -3.5 to 3.5 / 0 / 0.5 mm/step ]
[Original Size Priority]
Original Size Detection Priority
016
1 Original
Size
Priority
*
NV
CF
Specifies the original size for a size detected by
the original sensor, since original sensors cannot
recognize all sizes.
[ 0 or 1 / 0 / - ]
0: Setting 1
1: Setting 2
Setting 1
Setting 2
Bit 7 A4 (L)
LT (L)
Bit 6 11" x 15"
DLT (L)
Bit 5 DLT (L)
11" x 15"
Bit 4 LT (S)
US Exec (S)
Bit 3 LT (L)
8" x 10" (L)
Bit 2 LG (L)
F4 (L)
Bit 1 A4 (L)
16K (L)
Bit 0 8K (L)
DLT (L)
Bits used for detection differ depending on
destination as shown below.
Bit 7 to 6: Only for Japan
Bit 5 to 2: Only for US
Bit 1 to 0: Only for EU/AA