Ricoh G031, Руководство по обслуживанию

Страница: 344 / 345

Tech Service Bulletin No. G919 – 002
Page 3 of 4
9.
Input the target IP address 10. Input the target password (“sysadm”).
IMPORTANT: For Steps 11-13, please
Do not turn OFF the machine main power
Do not send any print data to the machine
Do not access an http:// internet page.
Do not connect with TELNET or FTP
11. The machine will display “Downloading NIC Update Program [BIN] to NIC", and begin downloading
the BIN file. This will take approximately 2 minutes, during which time the panel will show how much
has been competed (%).
12. The display will then change to “Downloading Flash Update File [UPD] to NIC”, and the machine will
begin downloading the UPD or UPP file. This will take approximately 3 minutes, during which time
the panel will show how much has been completed (%).
13. After the UPD or UPP file download has been completed, the machine will display “Unit updated”,
and will them begin formatting the NIB. Please wait for this to finish (at least 2 minutes), and if NIB
status sheet printing has been activated, please wait for the sheet to be printed out.
IMPORTANT: Since a firmware update also overwrites the actual program, which brings the firmware on line
(booting program), if the power is turned off before the 2 minutes have elapsed, the machine
will in most cases not come back on line (not recover).
Therefore, it is very important to
wait the 2 minutes after the "unit updated" message has displayed.
Continued…