Ricoh G031, Руководство по обслуживанию

Страница: 115 / 345

SERVICE PROGRAM MODE
SM 4-13 G031/G032
Serv
ic
e
T
a
b
les an
d
P
roc
e
dur
e
s
4.2.5 PRINTER ID
Overview
The user can buy fonts and install them in the printer hard disk. The font software
uses the printer ID to prevent the fonts from being downloaded to several printers
illegally. The fonts must be downloaded to one printer only.
The original printer ID is stored in the NVRAM on the printer control board in the
factory. The serial number of the printer control board is used for the ID. When the
printer control board is replaced in the field, the old NVRAM is installed on the new
board. In this case, the printer ID does not need to be restored.
When the NVRAM is cleared or changed because of a hardware problem, the
original printer ID must be restored.
Restoring the Printer ID
The printer ID can be stored using the service program mode as follows.
1. Turn on the printer while pressing the “Online” key and
“Escape” key together to enter the service menu.
NOTE: For the key locations, see “Enabling and
Disabling Service Program Mode”.
Use the “arrow” key.
Press the “Enter” key.
An 8-digit numeral appears.
2. Press the “Online” key, “Form feed”, “Menu” key, and
“Up arrow” key at the same time
A cursor will appear under the 1st digit.
Service Mode:
1. Main Scan
G031M528.WMF
Service Mode:
10. Serial Number
G031M510.WMF
Serial Number:
80900082
G031M511.WMF
Serial Number:
8 0 9 0 0 0 8 2
G031M512.WMF