Ricoh G031, Руководство по обслуживанию

Страница: 253 / 345

SERVICE TOOLS
SM A-5 G031/G032
A
PPE
N
D
IX
1.2.2 SERVICE TOOL MENUS
There are two service menus that include tools for downloading firmware. These
are the IC card boot service menu and the service tool menu.
IC Card Boot Service Menu
Entering This Menu
1. Turn the printer off.
2. Turn on DIP SW 1 on the printer control board.
3. Plug the IC card into the IC card adapter, then connect it to the option bus
connector on the printer control board.
NOTE: The G031 has two option bus connectors. The left connector can only
be used for this function.
Do not use a blank IC card.
4. Turn the printer on. The IC card boot service menu will be displayed.
Menu Contents
The IC card boot service menu contains the following features.
Menu Function
Update controller firmware using an IC card. Update Firmware
For details, see this appendix, and “Downloading New Controller
Software” in section 4 of the service manual.
Downloading firmware into the printer’s flash memory from a PC
through a parallel cable.
Download Firmware
See this appendix for details.
Download firmware to a DIMM card from a PC through a parallel
cable.
Copy to DIMM
See this appendix for details.
Download firmware to an IC card from a PC through a parallel
cable.
Copy to CARD
See this appendix for details.
Clear the NVRAM
Clear NVRAM
To clear the NVRAM, press the “Enter” key twice.
Normally, NVRAM clear should not be used.
Note: This resets all the settings stored in the NVRAM to their
default settings. This procedure is required only after
replacing the NVRAM chip.
TEST Print Print controller generated test pattern (Listed below – for factory
use only)