Ricoh Aficio SP C411DN, Руководство пользователя программного обеспечения

Страница: 232 / 354

Monitoring and Configuring the Printer
220
6
❖
Access type configuration
msh> snmp “number” type “access_type”
❖
Protocol configuration
msh> snmp {ipv4|ipv6|ipx} {on|off}
• Use the following command to set protocols “active” or “inactive”: If you
set a protocol “inactive”, all access settings for that protocol are disabled.
• Specify “ipv4” for IPv4, “ipv6” for IPv6, or “ipx” for IPX/SPX.
• {on} means “active” and {off} means “inactive”.
• All protocols cannot be turned off concurrently.
❖
Configuration of protocol for each registration number
msh> snmp “number” active {ipv4|ipv6|ipx} {on|off}
• To change the protocol of access settings, use the following command.
However, if you have disabled a protocol with the above command, acti-
vating it here has no effect.
❖
Access configuration
msh> snmp “number” {ipv4|ipv6|ipx} “address”
• You can configure a host address according to the protocol used.
• The network interface board accepts requests only from hosts that have
IPv4, IPv6, and IPX addresses with access types of “read-only” or “read-
write”. Enter “0” to have network interface board accept requests from any
host without requiring a specific type of access.
• Enter a host address to deliver “trap” access type information to.
• To specify IPv4 or IPv6, enter “ipv4” or “ipv6” followed by a space, and
then the IPv4 or IPv6 address.
• To specify IPX/SPX, enter “ipx” followed by a space, the IPX address fol-
lowed by a decimal, and then the MAC address of the network interface
board.
❖
sysLocation configuration
msh> snmp location
❖
Deleting sysLocation
msh> snmp clear location
Access type Type of access permission
no not accessible
read read only
write read and write
trap user is notified of trapmessages