Ricoh Aficio FX10, Руководство по обслуживанию

Страница: 105 / 284

System Switch 02
No FUNCTION COMMENTS
0
Memory file transfer
0: Disabled
1: Enabled 1: All messages in the memory (including confidential
rx messages) are sent to the fax number which is
programmed as the service station.
Always reset this bit to zero after transfer.
Cross reference
Service station number programming: Function 13
1-2 Not used Do not change the setting.
3
Memory file printout
0: Disabled
1: Enabled 1: All SAF files, including confidential messages, can
be printed using Function 54 or 55.
Always reset this bit after printing the messages.
4-5 Not used Do not change the settings.
6
7
Memory read/write by RDS
Bit 7 6 Setting
0 0 Always disabled
0 1 User selectable
1 0 User selectable
1 1 Always enabled (0,0): All RDS systems are always locked out.
(0,1), (1,0): Normally, RDS systems are locked out, but
the user can temporarily switch RDS on to allow RDS
operations to take place. RDS will automatically be
locked out again after a certain time, which is stored in
System Switch 03 (see below). Note that if an RDS
operation takes place, RDS will not switch off until this
time limit has expired.
(1,1): At any time, an RDS system can access the
machine.
System Switch 03
No FUNCTION COMMENTS
0
to
7
Length of time that RDS is
temporarily switched on
when bits 6 and 7 of
System Switch 02 are set to
“User selectable” 00 - 99 hours (BCD).
This data is only valid if bits 6 and 7 of System Switch
02 are set to “User selectable”.
The default setting is 24 hours.
System Switch 04
No FUNCTION COMMENTS
0
to
2
LCD contrast
Bit 2 1 0 Contrast
0 0 0 Brightest
0 0 1
↓
↓ ↓
1 1 0
↓
1 1 1 Darkest
Use these bit switches to adjust the contrast of the
LCD on the operation panel.
3
Dedicated transmission
parameter programming
0: Disabled 1: Enabled This bit must be set to 1 before changing any
dedicated transmission parameters.
4 Not used Do not change the settings.
SERVICE TABLES AND PROCEDURES June 10th, 1997
BIT SWITCHES
4-20