Ricoh A085, Руководство пользователя

Страница: 198 / 617

1.4 SP-9 ELECTRICAL COMPONENT CHECK
- How to turn electrical component on/off -
1. While pressing both 1 and 3 on the operation panel number keys, turn on
the main switch in order to access the SP mode.
NOTE: Release the number keys after confirming that the ADS indicator
and the copy counter number "0" are blinking.
2. Enter 9 using the number keys and then press the "# " key.
3. Enter the desired output number using the number keys.
NOTE: The output number entered will blink in the three digit indicator.
The two LEDs at each end of the manual ID level indicator will
light.
4. Press the start key to turn on the electrical component.
NOTE: When the selected electrical component is active, all the manual
ID level LEDs will light.
Pressing the start key while holding down the interrupt key turns
on the selected electrical component together with the main
motor.
5. Press the Clear/Stop key to turn off the electrical component.
6. To turn on another electrical component, repeat from step 3.
CAUTION:The motors keep turning in this output mode regardless of
upper or lower limit sensor signal. Do not keep the
electrical component on for a long time to prevent any
mechanical or electrical damage.
Output No. Electrical component
1 Main motor (M1)
2 High voltage supply - Charge corona (PCB7)
3
High voltage supply - Charge corona and grid bias without V
R
correction
(PCB7)
4
High voltage supply - Charge corona and grid bias for ID sensor pattern
(PCB7)
5 High voltage supply - Charge corona and grid bias for V
R
pattern (PCB7)
6 High voltage supply - Charge corona and grid bias for V
L
pattern (PCB7)
7 High voltage supply - Transfer corona (PCB7)
8 High voltage supply - Separation corona (PCB8)
9 High voltage supply - Development bias (PCB7)
10 ID sensor LED (S12)
11 V sensor LED (S13)
12 Scanner drive motor : Scanner moves forward and returns to the H.P. (M7)
13 Black development unit (NOTE)
SERVICE PROGRAM MODE 10 July 1992
4-20