Rice Lake Revolution 680 Synergy Plus, Техническое руководство

Страница: 17 / 80

Installation
© Rice Lake Weighing Systems ● All Rights Reserved 11
2.7 Sealing the Indicator (Optional)
Insert a lead wire seal through three fillister screws. This restricts access of the setup switch, electronics, electrical contacts and
Legal for Trade configuration parameters.
The audit jumper (J24) must be set to off to require pressing the setup switch for access to configuration parameters.
Figure 2-10. Sealing the Indicator – No Access
1. Reposition the two fillister head backplate screws to the lower right and lower right-center screws locations.
1. Torque the two backplate screws and setup screw as specified in
Section 2.4.2 on page 7 .
2. Navigate the sealing wire through the fillister head screws on the backplate and the fillister head screw at the bottom of
the enclosure, as shown in Figure 2-10 .
3. Seal the wire to secure.
2.8 Parts Kit Components
The recommended cable strip length is 0.25'' (7 mm) for all 680 connectors.
Part No. Description Qty
15631 Cable Tie, 3'' Nylon 4
15650 Mount, Cable Tie 3/4'' 2
193230 Screw, Mach M4 x 0.7 x 10 Phillips Pan Head SST 4
194219 Screw, Mach M4 x 0.7 x 10 Phillips Drilled Cheese Head SST 2
194446 Ferrite Core, Snap on Fair-rite 1
194488 Screw, Mach M4 x 0.7 x 6 Phillips Pan Head with External Tooth Washer SEMS 4
19538 Post Plug, Slotted Black Plastic Stem, 1/4 x 1, Seals Inside Cord Grip 3
195993 Connector, 6 Position Screw Terminal Pluggable 3.50 mm Black 3
195995 Connector, 4 Position Screw Terminal Pluggable 3.50 mm Black 1
195998 Connector, 5 Position Screw Terminal Pluggable 3.50 mm Black 1
30632 Bag, Plastic 5 x 8 1
42149 Bumper, Rubber Grommet 0.50 (OD) x 0.281 (ID) 4
53075 Clamp, Ground Cable Shield, Radius 0.078'' 4
75062 Washer, Bonded Sealing #8 7/16 (0.4375) OD SST 6
94422 Label, Capacity 0.40 x 5.00 1
Table 2-10. Parts Kit (PN 194477) Components
Note
Note