Page | 13
1. Slave ID: As per jumper setting as shown on page 4.
2. Function: Select Function as 03 Read Holding registers (4x).
3. Select quantity as 2.
4.
Select Display as “Hex”.
d) Once all settings are done, click on apply then select ok.
e) You should receive data in the main table as per below image.
f)
The procedure to set Slave ID through software setting is explained below with images. User can set 1 to
247 Slave ID through software setting. For example If user wants to set slave ID 247 then Send Hex value
F7FF (247) to address 0 as per below image.
