Reznor VS15LHE8, Инструкция по установке и эксплуатации

Страница: 30 / 60

2.2.6.5 Linear reflectors.
The linear heater reflectors are supplied
pre-punched with universal hole patterns.
Note: 30-50kW models have two reflector lengths
on each heater.
Refer to the detailed assembly drawings
(Figure 41 to Figure 50) for more details.
Starting at the far end, place one of the
reflectors onto the last two brackets (ensure
correct length reflector is fitted for 30-50kW
models).
Place the following reflector on the heater
so that it overlaps the previous reflector
and sits on top of the next bracket.
Repeat process for all remaining reflectors,
refer to section 2.2.6.6 for details of fixing
all reflectors to the brackets.
Note: All reflectors must be positioned/attached to the
brackets exactly as they are detailed in the assembly
drawings.
Figure 31. Intermediate U-Tube V reflector
M6 set pin
Locknut
Large
washer
Spacer
M6 set pin
Small
washer
Spacer not used on bracket
furthest from the burner on
both u-tube and linear heaters.
2.2.6.6 Reflector fixings
For U-Tube heaters the reflector fixing to
the bracket nearest the U-Bend does not
have a spacer. All other U-Tube reflector
fixings have the spacer fitted. For linear
heaters the reflector fixing to the bracket
furthest from the burner does not have a
spacer. All other linear reflector fixings
have the spacer fitted.
2.2.7 U-Tube, burner end cap.
Position the end cap with tube holes beneath
the reflector profile at the burner end with
the end cap flanges facing inwards. Fasten
to reflector using 4 off M5 pozi set pins and
washers.
2.2.8 U-Tube, U-Bend end cap.
Position the end cap with no tube holes
beneath the reflector profile at the U-Bend
end with the end cap flanges facing inwards.
Fasten to reflector using 4 off M5 pozi set
pins and washers.
2.2.9 Linear end caps.
Position one end cap beneath the reflector
profile at the burner end with the end cap
flanges facing inwards. Fasten to reflector
using 3 off M5 pozi set pins and washers.
Repeat process at other end of heater.
Note: Please note that on 15-25kW models the burner
end cap has a larger hole.
Figure 32. End cap burner side fasten
as shown M5 set pins and washers
Figure 33. M5 set pins and washers. Figure 34. M5 set pins and washers.
30