Reznor VS15LHE8, Инструкция по установке и эксплуатации

Страница: 14 / 60

The methods shown in the above figures are unacceptable,
due to undue stress on the hose and fittings.
Gas Category Gas Type Nominal Pressure (mbar) Max Supply (mbar) Min Supply Pressure (mbar)
I3P (30) Propane Gas (G31) 30 35 25
I3P (37) Propane Gas (G31) 37 45 25
I3P (50) Propane Gas (G31) 50 57.5 42.5
Figure 12. Figure 13.
Table 6 – Gas supply pressures
Figure 14. Single phase wiring
Figure 15. Typical VSUTE Wiring connections
1.10 Electrical Connection
This appliance must be earthed.
• Supply 230V 50Hz single phase.
• Standard heater 116W.
• Each burner only for herringbone and
double linear heaters 32W.
• Current rating 0.55 amp max (inductive).
• Fuse: external 3 amp
All electrical work should be carried out to
National Standards and local regulations
by a competent electrician.
The electrical connection to the heater
is made by means of a three pin plug-in
power connector. Live, neutral and earth
connections should be made via a flexible
supply cable to the power connector and
routed clear of the heater or tubes.
The flexible supply cables should be 0.5mm²
and comply with National Standards. The
wires in the mains lead are coloured in
accordance with the following code:
Green & Yellow Earth, Blue Neutral, Brown Live
It is recommended the heater or group of
heaters are controlled by thermostats, a
time switch and if required manual control
switches and a frost thermostat.
We recommend use of the Nortek Global
HVAC (UK) Ltd approved controls. Please
refer to the control manual for citing and
installation details. Where alternative manu-
factures controls are used, please refer to
their instructions for their citing and instal-
lation details.
Fused spar
Fan plugs into burner
14