Company Registered in England No: 4167649 VAT Registration No: 732 5692 25 BS EN ISO 9001:2008 No: LRQ 0964389
+44 (0)1204 699 959
Hyquip Limited New Brunswick Street Horwich Bolton Lancashire BL6 7JB UK
www.hyquip.co.uk
/web/index
40/56 Commissioning
Bosch Rexroth AG
, A6VE Series 63, RE 91606-01-B/07.2013
8 Commissioning
WARNING
Danger while working in the danger zone of a machine/system!
Danger to life, risk of injury or serious injuries!
▶
Pay attention to and rectify potential danger sources before operating the axial
piston unit.
▶
Nobody may stand in the danger zone of the machine/system.
▶
The emergency stop button for the machine/system must be within the
operator’s reach.
▶
Always follow the instructions of the machine/system manufacturer during
commissioning.
CAUTION
Commissioning of an incorrectly installed product!
Risk of injury and damage to equipment!
▶
Make sure that all electrical and hydraulic ports are connected or plugged.
▶
Only commission a completely installed
fault-free
product
with original
accessories from Bosch Rexroth
.
8.1 Initialcommissioning
During all work for commissioning the axial piston unit, observe the general
safety instructions and intended use detailed in chapter 2 "Safety instructions" on
page 8.
▶
Connect the gauge for operating pressure and case pressure to the specified
measuring points on the axial piston unit or in the hydraulic system, to check the
technical data at first operation.
▶
During the commissioning process, monitor the temperature of the hydraulic fluid
in the reservoir to ensure that it lies within the permissible viscosity limits.
8.1.1 Filling the axial piston unit
Professional filling and air bleeding is necessary to prevent damage to the axial
piston unit and to maintain correct function.
The axial piston unit should be filled with a filling unit (10 μm filter grade). The
axial piston unit must not be operated while it is being filled by the filling unit.
Use only a hydraulic fluid that conforms to the following requirements:
Details of minimum requirements for hydraulic fluid can be found in the Bosch
Rexroth data sheets 90220, 90221 or 90222. The titles of the data sheets can be
found in Table 1 "Required and supplementary documentation" on page 5. You
can find details of permissible and optimal viscosity in data sheet 91606.
