Company Registered in England No: 4167649 VAT Registration No: 732 5692 25 BS EN ISO 9001:2008 No: LRQ 0964389
+44 (0)1204 699 959
Hyquip Limited New Brunswick Street Horwich Bolton Lancashire BL6 7JB UK
www.hyquip.co.uk
/web/index
Installation 29/56
RE 91606-01-B/07.2013, A6VE Series 63,
Bosch Rexroth AG
2.
Before installation, completely empty the axial piston unit to prevent mixing with
the hydraulic fluid used in the machine/system.
L
R
W
Fig. 8: Direction of rotation
W
Alternating (counter-clockwise and clockwise rotation permissible)
L
Left
R
Right
The direction of rotation as specified on the name plate determines the direction
of rotation of the axial piston unit as viewed on the drive shaft, see chapter 5.3
"Product identification"
on page 19
.
7.4.2 Dimensions
The installation drawing contains the dimensions for all connections and ports on
the axial piston unit. Also observe the instructions provided by the manufacturers of
the other hydraulic components when selecting the required tools.
7.4.3 General instructions
Please keep in mind the following general instructions for installation of the axial
piston unit:
t
Note that you can expect certain installation positions to affect the control
device. Gravity, dead weight and case pressure can cause minor shifts in control
characteristics and changes in response time.
t
For combinations of multiple units, make sure that the respective case pressure in
each unit is not exceeded. In the event of pressure differences at the drain ports of
the units, the shared drain line must be changed so that the minimum permissible
case pressure of all connected units is not exceeded in any situation. If this is not
possible, separate drain lines must be laid if necessary.
The installation method for the axial piston unit depends on the connecting elements
to the output side. The following descriptions explain the installation of the axial
piston unit:
t
with a coupling
t
on a gearbox
