18
ENGLISH
GB
Continuous Temperature Cycle
The continuous temperature cycle is available on
condition that there are two or three product
probes.
By selecting the continuous temperature cycle the
system will propose following screenshot :
By pressing the area
it is
possible to change the operating cell temperature.
By pressing the area
it is
possible to change the product temperature at the
end of the cycle.
By pressing the area
it is
possible to change the fan speed.
To confirm the new settings press the
area
on the right bottom : the cycle will start .
During a current cycle, following screenshot will
be displayed :
While executing the cycle, each time the door is
closed, the system checks the proper insertion of
the various probes and the cycle ends only when
all inserted probes reach the desired temperature.
After reaching the temperature set for each probe,
the buzzer sounds, the display shows a message
and the temperature value of the related probe is
displayed in green. Below an example of a screen
where only one probe is at temperature.
Pressing on the area
the display show the
temperatures detected by the various probes, the
state of inputs / outputs and the alarms stored by
the system. To abort the current cycle press for at
least three seconds the area
.
Number of the current phase
Time from cycle begin
