Revision 1.2a
Page 23 of 25
Warning
Please Note
The specifications of the product detailed on this
Set-Up Guide may change without notice. RDM
Ltd. shall not be liable for errors or for incidental
or consequential damages, directly and indirectly,
in connection with the furnishing, performance or
misuse of this product or document.
Ensure that all power is
switched off before
installing or maintaining
this product
Mercury 2 & Intuitive Mercury EPR Stepper Installation
Guide
www.resourcedm.com
Example of resistor fitted on a probe input.
Inputs
Input resistance:
3.01K Ohms (for PTC or NTC type probes)
Input type
PT1000 or NTC2K or NTC2K25 or NTC10K (selectable)
Comms:
RS232 with flow control
Switched Resistor Example Wiring
Installation
Panel Cut-out and Clearances
Mercury Mk2 (Flush mount controller)
Dimensions
Mercury Mk2
Dimensions
Fixing
The controller is fixed by sliding the 2 plastic retaining
clips up to rear of the panel. These clips have a ratchet
action and can be removed by holding in the clip sides
and sliding back.
Connect to remote switch or relay
Probe Ground
Probe Signal
