Renson Endura Delta 330, Инструкция по установке и эксплуатации

Страница: 73 / 140

73
Endura
®
Delta
en
Installer
Select “RF Repeater” on the Sensor Controller using
▲
and
▼
, and
confirm by tapping
■
.
RF Repeater (only available with the Sensor Controller)
A Sensor Controller can be set as the RF Repeater using this menu. Setting the Controller as the
Repeater can be useful if another controller is too far away from the Main Controller. After all, it is
possible that a signal, generated on the other controller, cannot reach the Endura Delta. By setting
the Controller as the Repeater, the signal sent by the other Controller will be transferred through
another Controller that is closer to the ventilation system. The Controller then signals the ventilation
system.
To set the Sensor Controller as the RF Repeater, tap “Enable” using
■
.
To exit the menu, briefly tap
▲
and
▼
simultaneously.
Select “RF Information” on the Sensor Controller using
▲
and
▼
, and
confirm by tapping
■
.
RF Information (only available with the Sensor Controller)
You can control the signal strength of the wireless link between the Sensor Controller and the
Main Controller using this menu. Based on this information, it can be determined whether a
Sensor Controller must be set as an “RF Repeater”.