Renishaw apply innovation SPA2, Руководство по установке

Страница: 30 / 39

28 Hardware configuration of the SPA2
11. Fit the connection cable attached to the 4th axis interface card to the SPA 2 motherboard control
electronics. This connection is located at the rear left hand corner of the motherboard.
NOTE: Caution is advised when fitting the connection cable from the 4th axis interface card to the SPA 2
control electronics. It is recommended that the cable is inserted with minimal force using a finger below
the PCB to support the connector insert.
12. Fit the voltage supply cable loom from the 4th axis option card to the SPA
2
control electronics, as
shown in diagram below.
NOTE: Caution is advised when fitting the connection cable from the encoder option card to the SPA 2
control electronics. It is recommended that the cable is inserted with minimal force.
13. Refit the top panel of the SPA 2 enclosure by reversal of the method used in step 4 - 6.