REITER Respiro R9 profi, Руководство по эксплуатации

Страница: 72 / 74

68
Recommendations for the successful use of Respiro technology:
1. The machine may only be operated by trained personnel.
2. Machinery rings should choose the smallest possible number of drivers.
3. Before each use, check the most important points as described in the operating
instructions.
4. The highest priority when working with the belt rake is the uniformity of the swath. This
allows every harvester to deliver the best performance. If the windrow is uneven, this
reduces the efficiency of the subsequent harvesting technique enormously.
5. Even swaths are achieved when ...
a) the driving speed approximately coincides with the belt speed. The flow of the crop
must always be done without faltering. If the belt speed is too small, the effect of
"dripping" and thus heap formation begins
b) no sudden changes in working speed are made, especially by sharp braking
c) the first two rounds are swathed in the middle of the field; This is especially valid in the
field corners.
d) for operation in side delivery, in the corners deliver the swath outwards.
e) in sharp field corners raking is performed out of the corner, so the machine is pushed
backwards into the field corner and then begins the swathing
f) it does not accumulate on the belt when picking up already laid swaths at an oblique
angle, but the absorbed material can flow away unhindered
Right False
g) the rotor works in the lowest position, especially with short harvested crops, because it
optimally supports the crop flow
h) If there is a blockage on the belt, raise the rotors and eject the crop during forward travel.
This distributes the accumulated mass on the belt as well as possible at the desired location
i) The belts must not be reversed while driving in the direction
j) Make sure that the blets are running before feeding crop over the pick-up on the belt