REITER Respiro R9 profi, Руководство по эксплуатации

Страница: 24 / 74

20
Loadsensing operation: Worm screw with Imbuss key Wide ....... Turn inwards clockwise all
the way in and counter with nut (width across flats ......)
Attention: for the pressure circulation without load, the couplings of the load-sensing
pressure line and the return line on the tractor must be easy to turn.
If the pressure is too high these connections can no longer be turned => there is an error;
Danger of overheating => please contact customer service.
Operation with constant pump: Unscrew the worm screw counter clockwise and lock with
the nut.
pilot valve
3.9. Conveyor belt
Antrieb Förderband über Hydraulikmotor
und Kupplung
With wrench size 7 this set screw can be adjusted.
Factory setting: the piston of the valve is only lightly
touched with the adjusting screw and then fixed with
the lock nut.
For emergency operation, the flow can be adjusted
from zero to maximum, depending on the position of
the screw (fully screwed in).
Setting roller scraper:
Slightly loosen the screws on the front side of the belt
and the back side of the belt, it should still "clamp"
slightly.
Adjustment direction A: Scraper comes closer to the
roller
Adjustment direction B: Scraper moves farther away
from the roller.
Clean the roller as needed
1. Adjust scraper in direction A until the dirt on
the roller is removed. Let the belt run in both
directions.
2. Then distance the scraper from the roller so
far that no grinding noise can be heard.
3. The distance should be as small as possible for
a good cleaning effect (!)