3
ENGLISH
• Never touch the bulb with your bare hands, as oil from your skin can
cause premature failure. Always handle the bulb with gloves or a soft
cloth.
• Disassembly of your fixture will void the warranty.
• For supply connections, use wire rated at least 90 degrees C.
• In the event of glass breakage, the entire lens cover must be replaced
per UL requirements. Contact Customer Service for ordering
assistance.
Installing the bulbs
Step 1:
Remove glass lens cover by first removing the two (2) screws in
the back of the housing that hold glass lens cover in place.
Step 2:
Using a clean cloth or gloves, remove bulb from package and
protective wrap.
NOTE: Never touch bulb with bare hands as
oil from your skin can cause premature failure.
Step 3:
To install bulb, position bulb into spring loaded socket and push
bulb toward socket until it depresses. Position other end of bulb
into stationary socket (opposite socket). Be sure each end of
bulb is securely positioned against socket.
Step 4:
Replace glass lens cover. Insert and tighten the screws that
secure the glass lens cover.
Assembling your fixture
For mounting to eave or ceiling (J)
NOTE: This fixture has been preassembled
for ceiling or eave mounting.
Proceed to
Wiring your fixture
listed on page 4.
For mounting to wall (K)
NOTE: For use in wall mounted position, the
lights must be disassembled and reassem-
bled to the coverplate using the two addi-
tional threaded holes on the coverplate.
Step 1:
Unscrew both fixtures from eave mount-
ing position.
NOTE:
Position fixture
heads as shown (L) to facilitate ease of
disassembly from coverplate.
Step 2:
Unscrew the plugs from the coverplate
and screw the plugs into the eave
mounting position holes (M). If
plugs are stuck, tap lightly to
break paint seal.
Step 3:
Thread the mounting arm from
each light into the two remaining
mounting holes and secure with
the locknuts provided, using pliers.
J
L
K
Use for
Eave
Mounting
Use for
Wall
Mounting
M
TMQ I. S. 325-0369 6/17/04 2:50 PM Page 3
