Operation
50 — English
Servitec 35-120 with Touch controller — 06.07.2016 - Rev. B
8.2
Restarting
CAUTION
Risk of injury due to pump start-up
Hand injuries may occur when the pump starts up if you turn the pump motor at the impeller using a screwdriver.
•
Switch the pump to a zero-volts state before turning the pump at the fan wheel with a screwdriver.
ATTENTION
Device damage due to pump start-up
Pump damage may occur when the pump starts up if you turn the pump motor at the impeller using a screwdriver.
•
Switch the pump to a zero-volts state before turning the pump at the fan wheel with a screwdriver.
After an extended device standstill time (the device is disconnected from the power or in Stop mode), the pump may jam. For this
reason, use a screwdriver to rotate the pump at the fan wheel of the pump motor before restarting.
Note!
Jamming of the pump is prevented during continuous device operation by a forced starting action (after 24 hours).
