Reely Sky Micro, Руководство по эксплуатации

Страница: 40 / 112

40
c) Inserting the Flight Battery
The charged flight battery (1) is slid into the battery
holder (2) below the skid brackets. The battery
connection (3) must point backwards.
Slide the battery forwards until the plastics collar (4) of
the battery is flush with the rear holder.
d) Switching the Helicopter on
Move the control stick for the pitch and tail functions
(also see figure 1, item 8) to the bottom position and
switch on the transmitter.
Then connect the polarity-reversal protected plug of
the helicopter connection cable (1) to the flight battery
at once. Do not use any force when plugging in the
battery!
Right then, the electronics in the model helicopter per-
form an alignment. During this, the red LED on the
central circuit board (2) will flash and the helicopter must
not be moved. The figure also shows the receiver aerial
(3).
After approx. 5 seconds, the LED is permanently lit and
the two swash plate servos (4) on the right and left of
the central circuit board go into basic position. The
swash plate (5) then must be aligned horizontally (see
auxiliary line in the lower illustration of figure 7).
If the swash plate is tilted, use the trim or twist the
linkage rods to precisely adjust the swash plate. For
more information on this, see the following chapter
“Model Helicopter Start-Up”, section h) “Trimming the
Helicopter” and chapter “Fine Tuning of the Helicopter”.
Now your model helicopter is ready to start.
Figure 7
Figure 6